Post by bean44 on Apr 28, 2013 19:38:53 GMT -5
Straight Up Old School Demo Derby-Carrollton,Ky
« Thread Started Today at 7:27pm »
June 22,2013
1980 and Newer Stock-Entry Fee $40
1st Place-$2000 +Trophy
2nd Place-$300+Trophy
3rd Place-$200+Trophy
Mini Car Stock-Entry Fee$30
1st Place-$1000+ Trophy
2nd Place-$300+Trophy
3rd Place-$200+Trophy
Mini Car Figure 8-Entry Fee$25
100% Payback
Lawnmower Derby-Entry Fee-$25
100% Payback
Rules and Regulations
1. Any 1980 and newer sedan or wagon.
2. All cars are subject to re-inspection at any time.
3.The officials and drivers will inspect all cars before and after the feature.
4.Any controversy or protest must be brought to the officials' attention before the drivers meeting.
5.All officials decisions are final.
6.Helmets,seat belts,and eyewear are mandatory.
7.No alcohol permitted. If you are drunk you will not drive.
8.If you have any questions,call first.
Car Rules for Stock Big and Mini Cars
1.Tires black and round.
2.Suspension must remain stock.Must have travel front and back.
3.Rear end swaps are permitted.Must be stock and bolted into stock position-NO MODIFICATIONS! Five lug rear end only
4.No aftermarket rear ends or axles,.(Moser,Eaton,etc..)
5.Motor swaps are allowed and you can weld in motor mounts.
6.Batteries and gas tanks must be secured and covered.
7.No distributor or tranny protectors,engine cradles or aftermarket mounts.
8.All doors may be welded 5" on 5"off.Hoods and deck lids may be wired six places with two strands per hole.NO WELDING!!
9.Bupers may be welded on from front body mount out and the rear body mount out-No Exceptions.
10.22" Bumper height front and rear.
11.No welding on frames.No plates on frame.Only welding is motor mounts and bumpers-No exceptions.
12.No slider drive shafts.No aftermarket coolers allowed.Engine or transmission.
13.Full cage is recommended.You may have rollover bar.Cage cannot connect to floor.Rear bar must be 12" from front seat.
14.No gas tank protectors.
15.Body mounts:Must remain stock,no adding mounts,bolts must be stock diameter 7/16".No all thread on core support mounts.No homemade cross members.Must be stock
16.All steering must remain stock.No reinforcing tie rods
17.All glass,plastic, and interior must be removed
18.If you have any questions on any of rules,call first.
IF IT DOESN'T SAY YOU CAN DO IT-DON'T DO IT
Derby inspection will start at 1pm;all cars must be inspected no later than 6pm,so be on time.
All cars will be auctioned with 50%payback
Prizes will awarded to heat drivers,donated by local parts stores.
Powder Puff Derby also!!
SO COME RUN A TRUE STOCK DERBY AND HAVE FUN!!!
ANY QUESTIONS CALL Bobby at 502-817-4971
« Last Edit: Today at 7:28pm by bean4
Read more: we-crash.proboards.com/index.cgi?action=display&board=southern&thread=34915&page=1#ixzz2RoAv7q7A
« Thread Started Today at 7:27pm »
June 22,2013
1980 and Newer Stock-Entry Fee $40
1st Place-$2000 +Trophy
2nd Place-$300+Trophy
3rd Place-$200+Trophy
Mini Car Stock-Entry Fee$30
1st Place-$1000+ Trophy
2nd Place-$300+Trophy
3rd Place-$200+Trophy
Mini Car Figure 8-Entry Fee$25
100% Payback
Lawnmower Derby-Entry Fee-$25
100% Payback
Rules and Regulations
1. Any 1980 and newer sedan or wagon.
2. All cars are subject to re-inspection at any time.
3.The officials and drivers will inspect all cars before and after the feature.
4.Any controversy or protest must be brought to the officials' attention before the drivers meeting.
5.All officials decisions are final.
6.Helmets,seat belts,and eyewear are mandatory.
7.No alcohol permitted. If you are drunk you will not drive.
8.If you have any questions,call first.
Car Rules for Stock Big and Mini Cars
1.Tires black and round.
2.Suspension must remain stock.Must have travel front and back.
3.Rear end swaps are permitted.Must be stock and bolted into stock position-NO MODIFICATIONS! Five lug rear end only
4.No aftermarket rear ends or axles,.(Moser,Eaton,etc..)
5.Motor swaps are allowed and you can weld in motor mounts.
6.Batteries and gas tanks must be secured and covered.
7.No distributor or tranny protectors,engine cradles or aftermarket mounts.
8.All doors may be welded 5" on 5"off.Hoods and deck lids may be wired six places with two strands per hole.NO WELDING!!
9.Bupers may be welded on from front body mount out and the rear body mount out-No Exceptions.
10.22" Bumper height front and rear.
11.No welding on frames.No plates on frame.Only welding is motor mounts and bumpers-No exceptions.
12.No slider drive shafts.No aftermarket coolers allowed.Engine or transmission.
13.Full cage is recommended.You may have rollover bar.Cage cannot connect to floor.Rear bar must be 12" from front seat.
14.No gas tank protectors.
15.Body mounts:Must remain stock,no adding mounts,bolts must be stock diameter 7/16".No all thread on core support mounts.No homemade cross members.Must be stock
16.All steering must remain stock.No reinforcing tie rods
17.All glass,plastic, and interior must be removed
18.If you have any questions on any of rules,call first.
IF IT DOESN'T SAY YOU CAN DO IT-DON'T DO IT
Derby inspection will start at 1pm;all cars must be inspected no later than 6pm,so be on time.
All cars will be auctioned with 50%payback
Prizes will awarded to heat drivers,donated by local parts stores.
Powder Puff Derby also!!
SO COME RUN A TRUE STOCK DERBY AND HAVE FUN!!!
ANY QUESTIONS CALL Bobby at 502-817-4971
« Last Edit: Today at 7:28pm by bean4
Read more: we-crash.proboards.com/index.cgi?action=display&board=southern&thread=34915&page=1#ixzz2RoAv7q7A