BIG CAR SEMI-STOCK
1. If you break a rule, you lose that rule.
2. Any year no imperials
3. Helmet, seatbelt and eye protection must be worn at all times.
4. Drivers side seat belt must be in working order
5. Judges decision is final. Cars are subject to reinspection at any time.
6. We have the right to drill or cut any car at any time
7. If drivers door comes open or driver gets out during the heat the car will be disqualified
8. Driver will pay entry fee prior to car being inspected, everyone will pay at the gate
9. Double teaming--you will be warned once, second time you will be disqualified.
10. You will have a 1 minute time limit, to make an aggressive hit.
11. Any driver, pit crew, family member,etc. that fights or argues with any official will cause that driver and car to be disqualified.
12. There will be a $200 protest fee, this has to be a driver of feature car ONLY
13. If the rules dont say you can do it, then dont
14. All glass, chrome molding, hood latches, gas tanks, and rear seats must be removed before car arrives at fairgrounds.
15. Stock hood must be used. Hood must be open for inspection. Hood must be secured in 6 places, with 2inx2inx1/4in. No longer than 6inches with 3/8 bolts.
16. Radiators must stay in original location, can be wired on all four corners.
17. You may run an electric fan. All fans must be covered.
18. Factory condensers ONLY. They may be wired in not welded
19. You may use 1 inch all thread in core support with 3 inch max spacer.
20. Gas tanks must be relocated behind drivers seat, securely fastened and covered, any visable leaking fuel will result in disqualification. ALL plastic tanks must be in steel enclosure. Gas tank protectors are allowed it must be 4inches off the floor and 6 inches from back firewall. It CANNOT strengthen the car in any way
21. Batteries must be moved to the passenger side floor board, battery box CANNOT strengthen the car in any way. You may run 2 batteries
22. Sunroofs must be covered... No exceptions
23. You may run 4-point cage around the drivers compartment no bigger than 4x6 inches, can be welded to the car but not excessively. The front bar has to be 5 inches from the firewall and tunnel. You can wire cage to rails in four places using #9 wire. You can use after market sterring column, after market tie rods, front sway bar can be bolted to lower A arms, cannot be welded to the frame.
24. Transmission coolers or oil coolers are allowed. Transmission protectors are allowed.
25. Roll over bars are mandatory, MUST be straight up and down.
26. Doors can be welded shut using 3inx1/8in thick metal. Weld 6 on 6 off, Drivers door can be welded solid.
27. No welding on frames or body seams. this will be checked. NO PLATED FRAMES.
28. Factory body bolts and bushing MUST be stock. Broken body bolts can be fixed by using another factory body bolt.
29. You can pitch the front rails by only cutting outside flap then pulling down and rewelding the flap with one pass of weld.
30. No welding except bumpers and motor mounts.
31. Any year factory bumper which can be welding to shock and shock to frame. 12 inch bumper shocks allowed. The shocks can not be bigger than 2 inch square or round.
32. All cars must sit level within 5 inches with no car sitting lower than 16inch from bottom of bumper or higher than 21 from the bottom of the bumper. No wedged cars
33. Car must bounce. No solid bar or homemade shocks.
34. Cutting the ends off bumpers and fenders for clearance is permitted.
35. Motor swaps, rear end swaps and engine cradles are allowed.
36. Slip shaft and read end braces are allowed, but no kickers to the rails.
37. Trunk lids can be welded with 8 plates, maximum of 6 inches long 1/8 inchx3inch thick metal with 6 inch of space between them. Trunk needs to be standing up until after inspection, then you can swag the rear quarters to remain standing. Fresh car body creasing allowed after inspection. Window bars are allowed from back glass to lower part of speaker deck, not to trunk lid in any way.
38.You can run a dist. protector but your firewall must be cut out.
Read more:
www.kydemoderby.proboards.com/index.cgi?board=rules&action=display&thread=267#ixzz2JZbvqgsn